Instruction manual

196 ScreenPRO-II Controller • User’s Guide
5. System Setup
AUX Destination Setup
^ìñ=aÉëíáå~íáçå=pÉíìé
This section provides instructions for setting up an Aux destination.
 Use the following steps to set up an Aux destination:
1. Ensure that your have properly configured one (or more) router outputs as “Aux”
outputs. If not, refer to the “
Router Setup” section on page 193 for instructions.
2. From the Home Menu, press SYSTEM to access the System Menu.
3. Press {DEST SETUP} to display the Destination Setup Menu.
4. On the Destination line, select the Aux destination that you want to define —
either
Aux 1, Aux 2, Aux 3 or Aux 4.
5. Scroll to the Type line and select Aux.
6. Press {AUX SETUP} to display the Aux Setup Menu.
7. On the Source Mapping line, two choices are available:
~ Select Input Patch if you want to map Aux sources according to how
inputs are patched to buttons on the
Source Selection bus. Note that
this is the typical choice.
~ Select Direct Map if you want the Source Selection bus to be a 1:1
mapping of your router inputs — for
this Aux destination only.
8. On the Router Name line, select the router on which you configured the Aux
output(s).
9. On the Router Output line, select the specific router output that you wish to
designate as the Aux destination. Note that only outputs configured as “
Aux” will
appear in the list.
10. Press {BACK} to return to the Destination Setup Menu.
11. Repeat from step 4 to configure additional Aux outputs.
12. Press {BACK} to return to the System Menu.
13. Press {HOME} to return to the Home Menu.
14. Press {SAVE} to save the new system configuration in memory.
This completes the procedure for defining Aux destinations. The selected button(s) on the
Destination Bus
are now active.
fã~ÖÉmol=çê=mêÉmolJff=^ìñ=aÉëíáå~íáçå=pÉíìé
This section provides instructions for setting up an ImagePRO Aux or PrePRO-II Aux
destination.
 Use the following steps to set up an ImagePRO or PrePRO-II Aux destination:
1. Ensure that your have properly configured one (or more) router outputs as “Aux”
outputs. If not, refer to the “
Router Setup” section on page 193 for instructions.
2. From the Home Menu, press SYSTEM to access the System Menu.
3. Press {DEST SETUP} to display the Destination Setup Menu.
4. On the Destination line, select the Aux destination that you want to define —
either
Aux 1, Aux 2, Aux 3 or Aux 4.
5. Scroll to the Type line and select ImagePRO Aux or PrePRO-II Aux.
6. Press {AUX SETUP} to display the Aux Setup Menu.