Instruction manual

192 ScreenPRO-II Controller • User’s Guide
5. System Setup
Standard Destination Setup
pí~åÇ~êÇ=aÉëíáå~íáçå=pÉíìé
ScreenPRO-II Controller system setup: Step 7
In this procedure, you will set up the system’s “standard” destinations (single screen and
widescreen) on the Controller’s
Destination Bus.
S Prerequisites — Ensure that you are familiar with the Destination Setup
Menu
. In Chapter 4, refer to the “Destination Setup Menu” section on
page 117.
 Use the following steps to set up a single screen or a widescreen destination:
1. From the Home Menu, press SYSTEM to access the System Menu.
2. Press {DEST SETUP} to display the Destination Setup Menu.
3. Scroll to the Destination line and select the destination that you want to define —
either
1, 2, 3 or 4.
4. Scroll to the SP to Add line and select the ID of an available ScreenPRO-II. If a
ScreenPRO-II is already assigned to a destination, it will not appear in the list.
5. Press {ADD} to add the highlighted ScreenPRO-II to the destination. Once
added, the
ID will appear in the bottom portion of the menu. Please note:
~ For a Single Screen configuration, add only one ScreenPRO-II. Repeat
from step
3 to define all remaining single screen destinations.
~ For a Wide Screen configuration, add as many ScreenPRO-IIs as
required — up to the maximum of 4.
6. If required, scroll to the SP to Remove line and select the ID of a ScreenPRO-II
that you want to remove from the current configuration. Press
{REMOVE} to
clear the ScreenPRO-II from the destination.
7. Press {BACK} to return to the System Menu.
8. Press {HOME} to return to the Home Menu.
9. Press {SAVE} to save the new system configuration in memory.
This completes the procedure for defining single and widescreen destinations. The
selected buttons on the
Destination Bus are now active.
7
Note
Up to 4 “standard” destinations can be assigned (single
screen and widescreen), but only 1 widescreen destination is
allowed.
Note
When there are no more ScreenPRO-IIs available to assign,
the right-hand column displays
N/A.
Important
If the ScreenPRO-II Genlock Termination Menu appears
after you press
{BACK}, there is a termination switch
problem. In Chapter 4, refer to the “
ScreenPRO-II Genlock
Termination Menu” section on page 119 for details.