Instruction manual

ScreenPRO-II Controller • User’s Guide 191
5. System Setup
Restore from Flash Memory Card
oÉëíçêÉ=Ñêçã=cä~ëÜ=jÉãçêó=`~êÇ
ScreenPRO-II Controller system setup: Step 6 (optional)
In this procedure, you will restore your system configuration from flash memory — provided
that you previously backed up your system to the flash memory card.
S Prerequisite — Ensure that you are familiar with the Backup/Restore
Menu
. In Chapter 4, refer to the “Backup/Restore Menu” section on
page 141.
 Use the following steps to restore your system from the flash memory card:
1. Ensure that your flash memory card is properly inserted in the Controller’s
MEMORY CARD slot on the rear panel.
2. On the Home Menu, press MISC to access the Miscellaneous Menu.
3. Press {BACKUP RESTORE} to display the Backup/Restore Menu.
4. Press {CHECK CARD} to ensure that the Controller recognizes the card.
5. On the Device line, select Ctrlr+SP to perform a complete “restore.”
6. On the Controller Options line, select All.
7. On the SP to Restore line, select All.
8. Press {RESTORE} to restore the selected system configuration.
At the conclusion of this procedure, your system is completely set up — exactly the way
that you left it when you performed a complete system “backup.” No further setup
operations are required. Please continue with system operations. Refer to Chapter 6,
“
Operations” on page 215 for details.
6