Instruction manual

188 ScreenPRO-II Controller • User’s Guide
5. System Setup
System Power Up
açïåäç~ÇáåÖ=`çÇÉ
When an incompatibility exists between software code versions, all buttons will flash on the
Controller console. In this situation, the
Status Menu automatically appears with the
message “
Please Upgrade.”
 Use the following steps to download code from the Controller to the target device(s),
including ScreenPRO-II, PresentationPRO-II and BlendPRO-II:
1. From the Controller’s Home Menu, press SYSTEM > {SW VER} to display the
Software Version Menu. Any incompatibilities will be listed.
Figure 5-2. Software Version Menu (sample)
2. Press {DOWNLOAD CODE} to begin the download process, which takes several
minutes to complete.
During the procedure, several “progress” messages will be shown. When the entire
procedure is complete, the
Download Code Results Menu will display a summary of the
download. Please note:
• Results may appear on multiple pages.
• If required, press {PG DN} and {PG UP} to move between pages.
• Press {DETAILS} to view additional information for a specific download.
At the conclusion of the procedure, each ScreenPRO-II, PresentationPRO-II and
BlendPRO-II is running the same version of code as the Controller.
B
A
C
K
N
A
V
A
D
J
SOFTWARE VERSION
Controller 1.10
FORCE
DOWNLOAD
DOWNLOAD
CODE
BlendPRO-II 1.10
SP 1: 1.10 SP 2: 1.00
SP 3: 1.00 SP 4: 1.10
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Software version mismatch!
Download device(s) software
Software versions
incompatible with
Controller’s version