Instruction manual

186 ScreenPRO-II Controller • User’s Guide
5. System Setup
ID Setup and Remote Enable
fa=pÉíìé=~åÇ=oÉãçíÉ=bå~ÄäÉ=
ScreenPRO-II Controller system setup: Step 1.
In this procedure, you will set up individual ScreenPRO-II IDs and enable remote control.
Each ScreenPRO-II in your system must have a unique ID.
 Use the following steps to set up ScreenPRO-II IDs and remote control:
1. On an individual ScreenPRO-II system, press {REMOTE CONTROL} on the
Home Menu to access the Remote Control Menu.
2. Scroll to the Unit ID line, and select a unique ID for the ScreenPRO-II chassis.
The ID range is
1 to 32.
3. Scroll to the Remote Control/DHCP line, and enable remote control and DHCP.
4. Repeat steps 1 through 3 for all other ScreenPRO-II units in your system.
1
Note
When remote control is on, the {HOME} buttons disappears,
the ScreenPRO-II’s front panel is disabled, and the unit’s IP
address is dynamically assigned. All control now originates
from the ScreenPRO-II Controller’s console.