Instruction manual

146 ScreenPRO-II Controller • User’s Guide
4. Menu Orientation
Effects Menu
bÑÑÉÅíë=jÉåì
The figure below illustrates a sample Effects Menu:
Figure 4-48. Effects Menu (sample)
To access the menu:
• Press EFFECTS on the Home Menu.
The
Effects Menu allows you to modify and manage effects on a destination-by-
destination basis, including the ability to define key frames, paths and effect properties.
The following functions are provided:
• Destination — displays the currently selected destination.
• Key Frame Effect — enables you to select the type of motion for a “move.”
• Transition Rate — sets the auto-transition rate that is used when the Auto Trans
button is pressed. The transition value is in 0.1 second increments.
• Transition Wipe — sets the transition type when the WIPE button is selected.
Choose between
Wipe Right, Wipe Left, Wipe Down, Wipe Up, Curtain Open,
Curtain Close, Box In and Box Out.
• Transition Edge Width — When WIPE is selected, this field enables you to set
the transition’s edge type. The range (in pixels) is from
0 to 256.
In Chapter 6, refer to the “
Working with Transitions” section on page 241 for instructions.
H
O
M
E
N
A
V
A
D
J
EFFECTS MENU
Key Frame Effect LINEAR
Transition Rate 1.0
Transition Wipe Wipe Right
! Wide Screen destinations
only support Mix Transition
! Keyframe Effects are ignored
by ScreenPROII destinations
Transition Edge Width 16
Destination 1
Note
Only the Linear motion type is supported. All other key frame
effects are ignored by ScreenPRO-II destinations.
Note
Wide screen destinations only support Mix transitions. Key
frame effects are ignored by ScreenPRO-II destinations.