Instruction manual

132 ScreenPRO-II Controller • User’s Guide
4. Menu Orientation
System Menu
lìíéìí=m~íÅÜ=jÉåì
From the Router Specification Menu, press {OUTPUT PATCH} to display the Output
Patch Menu
.
Figure 4-34. Output Patch Menu (sample)
The Output Patch Menu allows you to associate router outputs to ScreenPRO-II inputs.
When a router is chosen on the
Router Specification Menu, you then use the Output
Patch Menu
to associate a specific output with a ScreenPRO-II ID and input. This process
creates a unique “
Output Patch Table” for each defined router.
The following functions are provided:
• Router Output — selects the specific router output that is being patched. The
selectable range is
1 to the number of outputs defined in the Router
Specification Menu
(e.g., 1 - 16).
• Device ID — selects the ScreenPRO-II ID to which the Router’s output will be
connected. The selectable range is
1 - 32.
• SP Input — selects the physical ScreenPRO-II input to which the router’s output
is patched.
• Mixer Layer — this line displays N/A, as it does not apply to ScreenPRO-II.
• Press {ADD PATCH} to confirm any change that you make on the menu. As you
dial through the choices, the “
SP Input is mapped to” lines will show if the current
choice is already in use. If the patch already exists and you “add” it, you will be
asked to confirm.
• Press {DELETE PATCH} to delete all “Output Patch Table” registers for the
selected router output. This function is an excellent starting point if you are
uncertain about specific output patch settings.
In Chapter 5, refer to the “Router Setup” section on page 193 for important information
about the system’s default
Output Patch Table.
B
A
C
K
N
A
V
A
D
J
OUTPUT PATCH
Router Output 1
DELETE
PATCH
SP 1Device ID
MATRIXPRO1
1SP Input
[ N/A ]Mixer Layer
SP Input is mapped to
MATRIXPRO1 Output 1
Set Device ID to NONE to define
the Router Output as an AUX.
ADD
PATCH
Note
If “None” is selected, the output is designated as an Aux
output.