Instruction manual

126 ScreenPRO-II Controller • User’s Guide
4. Menu Orientation
System Menu
DAs to similar ScreenPRO-II inputs, and enables all ScreenPRO-IIs to
switch simultaneously to the same input.
• Router Input — Applies to Router connections — this option selects the
physical router input that you wish to associate with the source. The available
range depends on the number of router inputs that are defined in the
Router
Specification Menu
.
• ScreenPRO-II Input — selects the specific input on the ScreenPRO-II.
• Tally Number — Applies to all connections — this option enables you to assign
any of the eight available tallies to any input source. There are no restrictions on
tally usage. For example, inputs
1 and 8 could both map to tally 1 if desired.
• Press {ADD PATCH} to confirm any change that you make on the menu. As you
dial through the choices, the “
SP Input is mapped to” lines will show if the current
choice is already in use. If the patch already exists and you “add” it, you will be
asked to confirm.
• Press {DELETE PATCH} to delete all input patch registers for the selected input.
When pressed:
~ The Connection Type setting changes to “UNDEFINED.”
~ The Router Input line is cleared.
This procedure is an excellent starting point if you are uncertain about specific
input patch settings.
In Chapter 5, refer to the “
Input Patching” section on page 198 for important information
about the system’s default
Input Patch Table.
Note
Asterisks around the ID number (e.g., *1*) indicate that the
selected ID has not been detected by the system. However,
you can proceed with patching, and once the ID is detected,
the patch will be completed as programmed.
Note
The same router input can be chosen for different source
numbers.