Instruction manual

120 ScreenPRO-II Controller • User’s Guide
4. Menu Orientation
System Menu
^ìñ=aÉëíáå~íáçå=pÉíìé
When Aux 1, 2, 3, or 4 is selected on the Destination Setup Menu, you can select one of
three types of Aux Destinations on the
Type line:
• Aux
• ImagePRO Aux
• PrePRO-II Aux.
In each case, the {
AUX SETUP} button appears, and when pressed, the Aux Setup Menu
appears — which enables you to set parameters for the selected Aux destination. Note
that the menu changes, depending upon the selected type of destination.
By way of definition:
• Each type of Aux destination can be switched from the ScreenPRO-II Controller
by selecting it on the
Destination Bus, and then selecting the desired source on
the
Source Selection Bus.
• An Aux destination is the output of a router, which is typically connected directly to
a monitor — rather than to the ScreenPRO-II. This type of destination is single
format (e.g., an analog monitor can only accept signals from an analog router).
• An ImagePRO Aux destination is an external ImagePRO, a multi-format
processor with three inputs (one analog, one SDI and one DVI) and the ability to
scale these inputs to one common output format. Typically, the ImagePRO output
is connected to another display device such as a monitor or projector.
• A PrePRO-II Aux destination is an external PresentationPRO-II, a multi-format
processor with nine inputs (eight analog and one SDI), and the ability to scale
these inputs to one common output format. Similar to ImagePRO, the PrePRO-II
output is connected to another display device such as a monitor or projector.
S For “standard” Aux destinations, press {AUX SETUP} to display the Aux
Setup Menu
:
Figure 4-26. Aux Setup Menu — Aux Destination (sample)
The following functions are provided:
• Top Line — displays the selected Aux destination number.
B
A
C
K
A
D
J
AUX SETUP
Source Mapping Direct Map
Router Name
Router Output
RESET
AUX_1
MATRIXPRO1
7
N
A
V