Instruction manual

ScreenPRO-II Controller • User’s Guide 119
4. Menu Orientation
System Menu
pÅêÉÉåmolJff=dÉåäçÅâ=qÉêãáå~íáçå=jÉåì
After having configured a wide screen destination, the ScreenPRO-II Genlock
Termination Menu
will automatically appear if the system senses that any of the
termination switches (in the
Widescreen Lock signal chain) are improperly set.
A sample
ScreenPRO-II Genlock Termination Menu is shown below:
Figure 4-25. ScreenPRO-II Genlock Termination Menu
This menu provides important information about the current status of your system’s
Widescreen Lock chain, and each ScreenPRO-II’s Termination Switch.
To correct the error:
• Review the menu information in detail.
• Follow the instructions as noted in the menu to change the physical position of the
termination switch(es) as instructed. For information on the termination switch, in
Chapter 3 refer to the “
ScreenPRO-II Genlock Termination” section on page 76.
• Press {CHECK TERM} to re-test the settings.
• If required, press {MORE} for additional “help” menus.
Note
In Chapter 3, refer to the “BlendPRO-II Widescreen Lock
Connections” section on page 77 for instructions on proper
Widescreen Lock connection.
B
A
C
K
N
A
V
A
D
J
SP-II GENLOCK TERMINATION
Current Termination Status
CHECK
TERM
SP 1: HI-Z
SP 3: 75 Ohm
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Set SP-II termination as follows:
Set to HI-Z: SP 3
Error: Termination setup incorrect
Press CHECK TERM to retest setting.
MORE
SP 2: HI-Z
SP 4: 75 Ohm
Important
If you press {BACK}, the ScreenPRO-II Genlock
Termination Menu
and the Destination Setup Menu will
endlessly loop — until the termination problem is fixed.