Instruction manual

118 ScreenPRO-II Controller • User’s Guide
4. Menu Orientation
System Menu
• SP to Add — (as you rotate the ADJ knob), lists all available ScreenPRO-II units
that can be assigned to the selected destination.
Units are identified by their ID
number.
If a ScreenPRO-II is currently assigned to another destination, it will not
appear in the list.
• SP to Remove — lists all assigned ScreenPRO-II units that can be removed from
the selected destination.
Units are identified by their ID number.
• Routing Mode — enables you to set the ScreenPRO-II’s routing mode — either
Internal or External. This function instructs the system how sources are used on
the assigned ScreenPRO-II unit(s).
• At the bottom of the menu, the Status section dynamically lists the ScreenPRO-II
IDs assigned to the current destination.
• Press {ADD} to add the selected ScreenPRO-II (on the SP to Add line) to the
current destination configuration.
• Press {REMOVE} to remove the selected ScreenPRO-II (on the SP to Remove
line) from the current destination configuration.
• Press {BACK} to return to the System Menu.
Important
If you have configured a widescreen destination, the moment
you press
{BACK}, the system automatically checks the
termination status of each ScreenPRO-II.
• If the termination switch is properly set on each
ScreenPRO-II, no action is required.
• If any termination switch is improperly set, the
ScreenPRO-II Genlock Termination Menu appears,
with instructions on how to correct the problem.
Refer to the “
ScreenPRO-II Genlock Termination Menu”
section on page 119 for details.