User's Manual

2. Xenon bulb lamp replacement process
2.3 Installation of the xenon bulb lamp
WARNING: DO NOT PERMIT UNAUTHORIZED PERSONNEL TO PERFORM OR ATTEMPT ANY PHASE O F
XENON BULB LAMP HA NDLING OR SERVICE.
WARNING: This procedure may only be performed by qualified technical service personnel.
CAUTION: Xenon comp act arc lamps are highly pressurized. Wh en ignited, the norm al operating temperature
of the bulb increases the pressure to a level at which the bulb may explode if not handled in strict accord ance
to the m anufacturer’s instructions. The bulb is stable at room temperature, but m ay still explode if dro pped
or o therwise mishandled. W henever the lamp h ouse, containing a xenon bulb lamp, has to be dismantled or
whenever the protective container or cloth has to be removed from the xenon bulb lamp, authorized protective
clothing MUST be worn!
WARNING: Always wear face protection (full face shield with neck protector) when handling xenon bulb
lamps.
WARNING: Alwa ys wear protective clothing (welder’s jacket) w hen handling xenon bulb lam ps.
WARNING: Always wear clean leather gloves w ith w rist protectors when handling xen on bulb lamps.
The DP-1200/DP-1500/DP-2000 projector is delivered without xenon bulb lamp installed. This procedure also
assumes that the lamp house is closed and that there is no xenon bulb lamp installed inside the lamp house.
Necessary tools
• 17 mm open ended wrench.
• Torque wrench with 17 mm hexagon socket
• Torque wrench with 5 mm Allen socket.
Necessary parts
• Lamp cathode adapter.
• Hexagon socket head screw M6 x 40.
• Plane washer.
How to install the xenon bulb lamp into the lamp house?
1. Ensure that you wear protective clothing, a full face shield and protective gloves.
2. Remove the UV blocker and side cover of the lamp
house by releasing the r etaining thumbscrews as illustrated.
Note: In case of a lam p replacement, the UV blocker will be already removed.
R59770175 XENON BULB LAMP REPLACEMENT 24/09/2008
13