Instruction manual

98 ACS-2048 • User’s Guide

_K==oÉãçíÉ=`çåíêçä=mêçíçÅçä

Remote Commands

oÉãçíÉ=`çãã~åÇë

This section lists ACS-2048 remote commands.

ae`m

• Description: Enable/Disable DHCP mode

• Command Format: DHCP -m (mode)

• Command Params: -m mode: 0-disable, 1-enable (default: on)

• Query Format: DHCP -?

• Query Response: DHCP -m (mode) --min 0 --max 1

• Description: Set Static IP Address to be used when DHCP is OFF

• Command Format: IP -s (static)

• Command Params: -s static addr with format xxx.xxx.xxx.xxx

• Query Format: IP -?

• Query Response: IP -a (active addr) -s (static addr)

• Response Params: -a (active addr): returns active address

pr_kbq

• Description: Set subnet mask to be used when DHCP is OFF

• Command Format: SUBNET -s (static addr)

• Command Params: -s static address formatted xxx.xxx.xxx.xxx

• Query Format: SUBNET -?

• Query Response: SUBNET -a(active addr) -s(static addr)

• Response Params: -a(active addr): returns active address

d^qbt^v

• Description: Set gateway to be used when DHCP is OFF

• Command Format: GATEWAY -s (static addr)

• Command Params: s static addr: format will be: xxx.xxx.xxx.xxx

SAVE System Save 105

LOCKOUT

Controls the lockout mode of the front panel 105

ISTAT

Query only command for the input status type and format. 105

OSTAT

Query only command for the output status type and format 105

Table B-1. ACS-2048 Remote Commands (Continued)

Command Description Page