Instruction manual

ACS-2048 • User’s Guide 93
_K==oÉãçíÉ=`çåíêçä=mêçíçÅçä
få=qÜáë=^ééÉåÇáñ
This appendix provides information regarding remote control protocol. The following
topics are discussed:
• Communicating with ACS-2048
• Command Protocol
• Error Codes
• ACS-2048 Command List
• Remote Commands
`çããìåáÅ~íáåÖ=ïáíÜ=^`pJOMQU
 Use the following steps to communicate with the ACS-2048 via Telnet:
1. Connect the ACS-2048’s Ethernet port to an Ethernet switch, and connect the
switch to your PC or laptop.
2. Ensure that all Ethernet parameters are properly set up. In Chapter 4, refer to the
“Ethernet” section on page 58 for details.
3. For Telnet communications, use the ACS-2048’s IP address and port 23. On a
Microsoft Windows PC, open a command prompt window and enter the following:
> telnet xxx.xxx.xxx.xxx 23
4. After you “Telnet” into the ACS-2048, are are presented with the login prompt:
Welcome to ACS-2048.
Login as “user”.
Press <ENTER> for password.
a. Type “user” and press ENTER to login.
b. When prompted for a password, simply perss ENTER.
Once you have successfully logged in, the following message appears, along with
the command prompt (>):
ShellApp waiting for input
>
5. You can now issue commands. Operationally, the telnet window functions in a
manner similar to a serial communications session. As required, type "help" to
see a list of supported commands.
Refer to the “Remote Commands
” section on page 98 for a complete list of commands.