Instruction manual

64 ACS-2048 • User’s Guide
4. Operation
Using the Main Menu
S Example: The Status Menu is currently displayed. When you
press TEST PAT, the Test Patterns Menu is immediately displayed.
~ When Menu Context is OFF, menu context does not change when an
Input or the TEST PAT button is pressed.
aá~ÖåçëíáÅë
From the System Menu, select Diagnostics to display the Diagnostics Menu:
Figure 4-37. Diagnostics Menu
If you suspect a problem with the ACS-2048, press SEL to run a series of internal
diagnostic tests. The menu will report back “PASS” or “FAIL.”
p~îÉ=póëíÉã=`çåÑáÖ
From the System Menu, select Save Config to save all current “system” settings so that
they may be restored at power up. A message is briefly shown, after which the ACS-2048
returns to the System Menu.
Figure 4-38. Saving System Configuration Message
Please note the following important points regarding the system configuration file:
• When you perform the Save Config function, all configuration parameters from
the System Menu are saved in non-volatile memory. If you do not perform the
function, data will not be restored upon the next system power up sequence.
• This command also saves the currently selected input channel as the default
selection upon power up.
• If you do not perform the Save System State function, data will not be restored
upon the next system power up sequence.
DIAGNOSTICS
> SEL = Start Tests
Note
If the menu report “FAIL,” please contact Barco Customer
Service. They will assist you with troubleshooting.
Saving System Config ...
Note
If you want the ACS-2048 to always power up and acquire an
input other than input 1, perform the Save System State
command while the desired input is selected.