Instruction manual

60 ACS-2048 • User’s Guide
4. Operation
Using the Main Menu
c. When the desired digit is highlighted, press SEL to edit the value. The
carat changes to the pound sign “#.”
d. Use the ADJUST knob to select the desired value (0 - 9).
e. Once the value is selected, press SEL to “accept” the new value. The
pound sign “#” changes back to the carat “^.”
f. Repeat the process from step b for all additional digits that you wish to
change.
g. When all editing is complete, press ESC to display the Apply Changes
Menu.
•Select Yes (SEL) to apply all changes.
•Select No (ESC) to exit the procedure without saving changes.
In each case, system returns to the root menu (Static IP, Gateway, or
Netmask).
When Ethernet setup is complete, you can communicate with the ACS-2048 via
the Ethernet. Refer to the “Remote Commands
” section on page 98 for details.
• IP Address — The IP line is an information-only line that shows the current IP
address in all modes (with DHCP on or off). If an IP address has not been
established (no DHCP server found, or the network cable is not connected), the
address reads "000.000.000.000."
• MAC Address — The M line is an information-only line that shows the MAC
(hardware) address of the unit's Ethernet port.
bafa=asf=fåéìí=cçêã~í
From the System Menu, select EDID DVI In Frmt to display the EDID DVI Input Format
Menu, which enables you to update the preferred EDID resolution for the ACS-2048’s two
DVI inputs (2 and 3).
Figure 4-29. EDID DVI Input Format Menu (sample)
EDID (Extended Display Identification Data) is a VESA standard data format that contains
information about a display device and its capabilities, including the preferred (as well as
the allowed) device resolutions.
The ACS-2048’s EDID file is stored in non-volatile memory. This file is read by a
computer's DVI graphics card during boot-up, when its DVI output is connected to a DVI-I
input connector on the ACS-2048 system (inputs 2 and 3). The ACS-2048 must be
powered on first for the EDID information to be read.
Note
The ACS-2048’s default IP address is 192.168.0.1.
EDID DVI IN FORMAT
> Input All
1024x768 @59.94
Program EDID
Important
This menu is designed for advanced users only. Do not
reprogram EDID unless it is necessary.