Instruction manual

58 ACS-2048 • User’s Guide
4. Operation
Using the Main Menu
Note that transition times are specified for switching applications with Auto
Acquire turned OFF. When Auto Acquire is ON, the transition time is greater,
due to the additional time required to analyze the input video timing.
Transition values are listed below:
• Adjustment range: 1.5 - 5.0 seconds
• Default: 2.0 seconds
sca=_êáÖÜíåÉëë
From the System Menu, select VFD Brightness to control the intensity of the front panel
VFD (vacuum fluorescent display).
• Adjustment range: 1 - 15 (1 is the dimmest setting)
• Default: 10
bíÜÉêåÉí
From the System Menu, select Ethernet to display the Ethernet Menu:
Figure 4-24. Ethernet Menu (sample)
The following Ethernet functions are available:
• DHCP — DHCP can be turned OFF or ON.
~ When OFF, the Config Network field appears, which enables you to
manually enter a static IP address, Subnet mask and Gateway.
~ When ON, the ACS-2048 queries the DHCP server for a valid IP
address, and the Config Network field is hidden.
• If the ACS-2048 finds a DHCP server and receives an IP
address, the address is displayed.
• If a server is not found, an IP address is not assigned.
Note
It is recommend that you use a low intensity setting to avoid
"burn-in" of the display.
ETHERNET
> DHCP OFF
Config Network >>
IP 192.168.000.001
M 00:04:a5:17:10:b0
Note
Always consult with your network administrator to obtain valid
IP, subnet mask and gateway addresses.