Instruction manual

34 ACS-2048 • User’s Guide
4. Operation
Quick Setup and Operations
10. Connect inputs — Connect all inputs to the ACS-2048, and check for the proper
backlight, which indicates that sync is detected. (Chapter 3, “Signal Installation”
on page 29. This chapter, “Understanding Backlighting” on page 68.)
11. Select and adjust inputs — As required, select an input, and perform the
necessary adjustments, such as crop, brightness, contrast, color balance, and
timing. (This chapter, “Input Menu
” on page 43.)
12. Save input configuration — After completing all adjustments for an input, save
the input configuration. (This chapter, “Save Input Config” on page 51.)
13. Repeat for each input — repeat steps 10 and 11 for each input that you have
connected to the ACS-2048.
14. Adjust system parameters — As required, adjust all desired system parameters
such as transition time, display brightness, and your user preferences. (This
chapter, “System Menu” on page 57.)
15. Save system configuration — After completing all system adjustments, save the
system configuration. (This chapter, “Save System Config” on page 64.)
16. Ready to roll — With all output, input and system configurations saved, press the
desired input button, and begin your presentation. Ensure that the button is lit,
indicating that the signal is valid.
Note
For advanced system operations, specific system “tweaks”
and operating descriptions on every feature, please start with
the “Quick Function Reference
” section on page 38, and
select the function that you wish to perform.