Instruction manual

ACS-2048 • User’s Guide 33
4. Operation
Quick Setup and Operations
Figure 4-4. System initialization message 4
The “version” line in the above menu shows the software version that is currently being
executed. This version number will change as software upgrades are released.
nìáÅâ=pÉíìé=~åÇ=léÉê~íáçåë
For the optimum speed in system setup and operations, use the following steps. For
reference, links are provided to pertinent sections in this guide.
1. Determine output mode — Determine the output operating mode of the ACS-
2048, and connect output cables accordingly:
~ If you elect to operate in 8-bit mode, ensure that Output Connector A is
connected to the projector’s DVI input A.
~ If you elect to operate in 10-bit or 12-bit mode, ensure that output
Connectors A and B are connected to the projector’s DVI inputs A and B.
In Chapter 2, refer to the “ACS-2048 Rear Panel” section on page 23.
2. Connect power — Ensure that power is properly connected to the ACS-2048. In
(Chapter 3, “Power Installation” on page 27.)
3. Connect Ethernet — Ensure that Ethernet is properly connected to the ACS-
2048. (Chapter 3, “Signal Installation” on page 29.)
4. Turn on power — Turn on power to the ACS-2048, your projector, and to all
peripheral devices as required. (This chapter, “Power-Up Initialization
” on
page 32.)
5. Set output format — Set the desired output format. There are two choices:
~ 2048x1080p @ 59.94Hz
~ 2048x1080p @ 50Hz
(This chapter, “Output Format
” on page 53.)
6. Set output mode — Set the desired output mode to 8-bit, 10-bit or 12-bit. (This
chapter, “Output Mode” on page 53.)
7. Adjust output — As required, scale the output to fit the actual projected image.
(This chapter, “Output Adjust” on page 55.)
8. Save output configuration — After completing all output adjustments, save the
output configuration. (This chapter, “Save Output Config” on page 56.)
9. Enable test pattern — Turn on the desired test pattern, and verify that you have
an image on your projector. When complete, turn off the test pattern. (This
chapter, “Test Pattern
” on page 54.)
ACS-2048
Barco
Version 1.00
Initializing ...