Instruction manual

ACS-2048 • User’s Guide 23
2. Hardware Orientation
ACS-2048 Rear Panel
^`pJOMQU=oÉ~ê=m~åÉä
The figure below illustrates the ACS-2048 rear panel:
Figure 2-1. ACS-2048 Rear Panel
Following are descriptions of each rear panel connector:
1) DVI Outputs
Two DVI-D connectors (A and B) are provided for the system’s dual-channel
(Twin-Link) DVI output. These outputs provides a 10-bit or 12-bit (4:4:4 RGB)
signal as follows:
~ Connector A: 8 msb (most significant bit). Only 8-bit output mode can
be selected on this connector, providing standard 8-bit DVI output.
~ Connector B: 2 or 4 lsb (least significant bit), depending on the output
selection. To increase color depth, 10-bit or 12-bit output mode can be
selected on this connector. Use the Output Menu to change the output
mode and bit-width. In Chapter 4, refer to the “Output Menu
” section on
page 53 for details.
Please note:
~ In 10-bit or 12-bit mode, both outputs (A and B) must be connected to the
projector. In 8-bit mode, a connection is required from Connector A only.
~ HDCP encryption is provided on both connectors A and B.
~ Frame rates of 50Hz and 59.94Hz are supported.
In Appendix A, refer to the “Output Specifications
” section on page 83 for
details, and the “DVI-I Connector Pinouts
” section on page 87 for pinouts.
2) Ethernet
One RJ-45 connector is provided for 10/100BaseT Ethernet communications with
the ACS-2048 system. The port is typically used for diagnostics or command-line
operations via Telnet (using port 23).
S telnet 192.168.1.100 23
In Appendix A, refer to the “Ethernet Connector
” section on page 88 for pinouts.
A B
100 - 240 VAC
50 – 60 Hz, 1.0A
10/100 BASE-T
DVI OUT
Model
ACS-2048
2
3
1
1) DVI Outputs 3) AC Power
2) Ethernet