User manual

CHAPTER 5

General Maintenance and Troubleshooting

intellaspot

XT-1 User Manual 69

pen appears to touch its reflection. On the uncoated side, there appears to be a

gap between the pen and its reflection

9. Insert the new wedge into the slot aligning the tab with the clip on the hub.

Note: There are two wedge shapes on the static color wheel. The wedge type with an outside

tab must always remain in the position directly opposite the open position. When

ordering color wedges be sure to specify whether it should be a tabbed or a standard

shaped wedge.

For dichroic wedge specifications,

see the intellaspot support page at

www.highend.com/support/

automated_luminaires/.

10. Slide the module back into the fixture

and tighten the thumbscrew screw to

secure it.

11. Replace the harness grommet into the

slot alongside the module

12. Reattach the bezel and retighten the

captive bezel screws.