User manual

CHAPTER 4
Fixture Programming
intellaspot
TM
XT-1 User Manual 57
Control Parameter
The Control parameter allows remote control of Pan and Tilt MSpeed, Display, Homing, Lamp and
Shutdown.
Note: To access all control settings (except for Pan & Tilt MSpeed Off), first
select a control channel value, then set the Shutter channel to “0.”
Control Parameter Setting Description
Safe Disables all Control settings for normal operation
Pan & Tilt MSpeed Off Sets Pan & Tilt MSpeed off
Display/LEDs Off Turns display and status LEDs illumination off
Display/LEDs Bright Turns display and status LEDs illumination on
Home All Remotely homes the fixture
Lamp On Remotely restrikes the fixture’s lamp
Lamp Off Remotely extinguishes the fixture’s lamp
Outrig Mode On Enables outrig mode for fixtures mounted sideways from wall or truss
Outrig Mode Off Disaples outrig mode
Shutdown
Remotely shuts down the fixture. When a fixture is shut down, the
lamp is extinguished, power to the motors is disabled, and the display
reads
Shutdown. If a fixture is in shutdown mode, the fixture must be
homed to bring it back into operation.