User manual
CHAPTER 3
Menu System
34 intellaspot
TM
XT-1 User Manual
Setup Motors
This option is used when calibrating flag motors in
Production Homing, see
Production Homing on page 51.
To run the motor setup routine:
1. Navigate to and select the TestOptionsMenu,
(see Test Options Menu on page 32).
2. Using the left and right arrows on the Center
button, scroll to the
SetupMotorsoption and press
the Enter button to select.
Use the up and down arrows on the Center button to
scroll to
On and press the Enter button to select and start the motor setup routine.
Encoders
Encoders maintain the Pan and Tilt position of the
fixture, but may need to be disabled to perform certain
test and maintenance procedures like optimizing a new
lamp.
To disable encoders:
1. Navigate to and select the TestOptionsMenu,
(see Test Options Menu on page 32).
2. Using the left and right arrows on the Center
button, scroll to the
Encodersoption and press the
Enter button to select. The default option is
On.
3. Use the up and down arrows on the Center button to scroll to Off and press the Enter button
to disable the pan and tilt encoders.
Code Menu
This option is for factory use only in debugging situations.
DMX
[
]
SetupMotors:
Off
DMX
[
]
Encoders:
On