User manual

CHAPTER 3
Menu System
intellaspot
TM
XT-1 User Manual 33
Copying the Boot Code
When new software is uploaded to intellaspot fixtures, it may contain a new boot code which
must be copied to each fixture. This is apparent if the fixture displays a
BOOTDIFFerror.
To accept and store the new boot code:
1. Navigate to and select the TestOptionsMenu, (see Test Options Menu on page 32).
2. Using the left and right arrows on the Center button, scroll to the CopyBoot option and
press the Enter button to select.
3. Use the up and down arrows on the Center button to scroll to the YES option and then press
the Enter button to store the command. The fixture will store the new boot code and then
automatically home.
Self Test
This option lets you test the mechanical function of
separate component or all of the components
in sequence.
To perform a self test:
1. Navigate to and select the TestOptionsMenu,
(see Test Options Menu on page 32).
2. Using the left and right arrows on the Center button,
scroll to the
SELFTestoption and press the Enter
button to select.
3. Use the up and down arrows on the Center button to scroll to the specific component or to
All and press the Enter button to select. The fixture will test the mechanical operation of the
selected component. If you selected All, every function is tested in sequence.
Display Test
To start a routine that tests display function:
1. Navigate to and select the TestOptionsMenu,
(see Test Options Menu on page 32).
2. Using the left and right arrows on the Center
button, scroll to the
DisplayTestoption and
press the Enter button to select.
3. Use the up and down arrows on the Center button
to scroll to
On and press the Enter button.
CAUTION:Do not remove power from the fixture while performing a
boot copy.
DMX
[ ]
SelfTest:
Pan
DMX
[ ]
DisplayTest:
Off