User manual
CHAPTER 3
Menu System
intellaspot
TM
XT-1 User Manual 29
Lamp Life Limit
Use this menu option to display the warning message
LampLifeError when the current lamp hours reach the
rated lamp life. When the LampLifeLimit parameter is
enabled, the fixture tracks the number of hours the lamp
is on. As the lamp life approaches it’s limit, the fixture
displays an error message. At close to the lamp life limit,
the lamp shuts off, and the fixture will not strike until the
lamp is replaced and the lamp hours are reset to 0. See
Replacing the Lamp on page 43 and Lamp HR/Strike
Reset on page 39.
To enable the LampLifeLimit parameter:
1. Navigate to and select the SetParametersMenu, (see Set Parameters Menu on page 27).
2. Using the left and right arrows on the Center button, scroll to LampLifeLimit.
3. Using the up and down arrows on the Center button, choose the Enable option and press
Enter to select.
Lamp Level
This menu option lets you choose the lamp power economy mode setting operating the lamp at
700W or the standard 850W mode.
To change the LampLevel:
1. Navigate to and select the SetParametersMenu, (see Set Parameters Menu on page 27).
2. Using the up and down arrows on the Center button, scroll to Lamp Level.
3. Using the up and down arrows on the Center button, choose the EconoMode or the
StandardMode and press Enter to select.
Data Loss Timeout
This menu option determines how the fixture will react in
the event of DMX data loss. Set the
shutter to stay open
until shutdown or to close one second after data loss.
To set the DataLossTimeout:
1. Navigate to and select the SetParametersMenu,
(see Set Parameters Menu on page 27).
2. Using the left and right arrows on the Center button,
scroll to
DataLossTimeout.
3. Using the up and down arrows on the Center button,
choose
Long to keep the shutter open until shutdown, or Short to close the shutter 1 second
after data loss and press the Enter button to select.
DMX
[
]
DMX
[
]
LampLife
Limit:Disabled
DMX
[
]
DataLoss
Timeout:Short