User manual

CHAPTER 3
Menu System
28 intellaspot
TM
XT-1 User Manual
Pan/Tilt Swap
This option swaps the pan motor and tilt motor operation
to coordinate movements between fixtures on a link
mounted perpendicular to each other.
To swap Pan and Tilt:
1. Navigate to and select the SetParametersMenu,
(see Set Parameters Menu on page 27).
2. Using the left and right arrows on the Center button, scroll
to Pan/TiltSwap. The current state (Enabled or Disabled)
will be displayed.
3. Use the up and down arrows on the Center button to scroll to
Enabled to swap pan and tilt or Disabled to restore default
setting and press the Enter button to select.
Pan Invert
This menu option inverts the direction of
the pan motor to coordinate movements
between fixtures mounted opposite each
other horizontally.
To invert the fixture’s Pan motion:
1. Navigate to and select the SetParametersMenu (see Set Parameters Menu on page 27).
2. Using the left and right arrows on the Center button, scroll to Pan invert. The current state
(
Enabled or Disabled) will be displayed.
3. Use the up and down arrows on the Center button to scroll to Enabled to
invert Pan movement or Disabled to restore default setting and press the
Enter button to select.
Tilt Invert
This menu option inverts the direction of the tilt motor to coordinate movements
between fixtures on a link facing each other vertically.
To invert the fixture’s Tilt motion:
1. Navigate to and select the SetParametersMenu (see Set Parameters Menu
on page 27).
2. Using the left and right arrows on the Center button, scroll to Tilt Invert.
The current state (Enabled or Disabled) will be displayed.
3. Use the up and down arrows on the Center button to scroll to Enabled to
invert Tilt movement or Disabled to restore default setting and press the
Enter button to select.