User manual

CHAPTER 3
Menu System
intellaspot
TM
XT-1 User Manual 27
Set Parameters Menu
The Set Parameters menu lets you configure your
fixture’s motion, display, lamp, and data source settings.
To enter the set menu:
1. Press the Menu button to unlock the menu system
or to move back up the system to the top level
menus.
2. Using the left and right arrows on the Center
button, scroll through the top level to
Set
ParametersMenu
and press the Enter button to
select. The screen will display the SET icon in the
screen banner and the first option of the next menu
level.
Factory Default Settings
This option lets you return all factory options to their
default settings or changes the factory options
individually.
An intellaspot fixture ships with the following factory default settings:
If any of the default settings are changed, this menu reverts to the Off option. The On option
restores all factory defaults.
To check and reset factory defaults:
1. Navigate to and select the SetParametersMenu as shown above. FactoryDefault
Settings
is the first option in the next Menu level with the current state. On is the default
and
Off indicates that a factory default has been changed.
2. Press the Enter button to select.
3. To reinstate the factory defaults if Off is displayed, use the up and down arrows on the
Center button to scroll to
ON and press the Enter button to select. All settings will be
restored to their factory default setting.
Pan Tilt Swap = Disabled Tilt Invert = Disabled Lamp Life Limit = Disabled
Pan Invert = Disabled Display Level = On Data Loss Timeout = Short
Data Source = DMX Lamp Strike Mode = Auto LED Level = On
FactoryDefaultSe
DMX
[ ]
FactoryDefault
DMX
[ ]
SetParameters
Settings:On
Menu