User manual

CHAPTER 2
Setup and Configuration
intellaspot
TM
XT-1 User Manual 13
Setting the DMX Start Channel
Each intellaspot fixture requires a block of 39 consecutive channels on a standard DMX512 link.
Up to 13 standard intellaspot fixtures can be assigned to a single link. For more information on
Start Channels, see
Determining DMX Start Channel Assignment on page 26.
Address your fixture by setting the start channel of the
To Set the Start Channel on an intellaspot fixture:
1. Access the fixture’s menu system via the LCD display on the fixture’s front panel. For a
detailed description of the menu system, see Chapter 3: Menu System on page 17.
Note: Navigation system buttons’ functions invert automatically when the
fixture is turned upside down.
2. Unlock the menu system by pressing and holding down the Menu button until the extended
2-line display appears.
DMXAddressMenuis the first option at the top menu level.
3. Press the Enter button to select. The display will show SetDMXStartChannel:###. The
display will show the start channel currently assigned to the fixture.
4. Use the Up and Down arrow buttons on the Center button to select a new DMX start
channel. The display will flash a new option ready for selection.
Note: The last valid Start channel for an intellaspot fixture is based on its 39-channel
range. The last valid start channel for an intellaspot fixture is 474 (512–39+1).
5. Press the Enter button to store the new DMX Start channel. The display will stop flashing
when a new option is entered.
Use LEFT and RIGHT arrows to
move through the current
menu level options
Use UP and DOWN arrows to
select from available value or set-
ting options.
Use the MENU button (on the left
when viewing the display) to
unlock the menu and move back
to the previous menu level
Center Navigation Button
Use the ENTER button (on the
right when viewing the display)
to enter a menu option or store
a selected menu value.