User manual

CHAPTER 2
Setup and Configuration
intellaspot
TM
XT-1 User Manual 9
Mounting the Fixture
You can mount your intellaspot fixture suspended from a support system (such as a truss) or
freestanding on its base.
Note: Due to the wide variety of possible lighting designs, High End Systems
cannot make specific mounting recommendations. Consider the following
procedure as a suggested guideline only.
Mounting the Fixture Upright
To mount the fixture upright:
1. Place the fixture on a sturdy, stable non-flammable surface that will support more than the
52.2 kg (115 lb) weight of the intellaspot fixture. If the surface is above floor height, use
safety cables to secure the fixture to the surface.
2. Disengage Pan and Tilt locks before powering up the fixture.
WARNING!
Equipment suitable for dry locations only. Do not expose this
equipment to rain or moisture.
CAUTION!
intellaspot fixtures must be installed and operated by trained
personnel only.
Always use a secondary safety cable when mounting this fixture.
Do not mount within 2 meters (6.56 feet) of a flammable object.
CAUTION!
Do not mount the fixture upright without the four rubber feet
attached.