Manualshelf

User manual

ManualsBrandsBarco Lighting Systems ManualsFlood LightTechnoArc
21222324252627282930
intellaspot
TM
XT-1 User Manual 7
Chapter 2:
Setup and Configuration
Installation of your intellaspot fixture includes mounting, connecting to
power and DMX linking and configuration.
Use the following steps to set up and configure your fixture:
1. Unpack the fixture.
2. Install power cord cap for your location.
3. Mount the fixture upright or suspended from a standard truss.
4. Connect the fixture to a DMX controller via DMX cabling.
5. Configure the fixture for DMX control using the battery mode or after connecting
to power.
Unpacking the Fixture
The intellaspot fixture ships in a box or an optional road case specifically designed to protect
the product during transport. When unpacking, inspect the fixture for physical damage to
components. High End Systems
®
assumes no responsibility for products that are damaged
during transport. Return a product for repair in its road case.
Before sending anything to the factory, call your High End Systems dealer/distributor
for a Return Material Authorization (RMA) number. The factory cannot accept any
goods shipped without an RMA number.
Pan and Tilt Locking
The intellaspot fixture ships with pan and tilt latches locked. You can unlock/adjust these
latches to stabilize the fixture for mounting.
Note: Disengage Pan and Tilt locks before operating the fixture.