Installation Instructions

INSTALLATION INSTRUCTIONS

P 847•244•1234 www.barclayproducts.com

6/25/09

Pop-up Instructions

1. Put 1 rubber washer onto body, sliding it up to drain cap.

2. Place pop-up into sink drain hole.

3. Slide 2nd rubber washer onto body from below sink.

4. Slide metal washer onto body from below sink.

5. Thread nut onto body and tighten.

Connect drain to trap

1. If using FV’s washbasin trap (Model# U242 or U242.01) follow instructions included with trap.

2. If not using FV’s washbasin trap, use following instructions:

a. Slide the washer onto the tube extender.

b. Slide the slip nut onto the tube extender.

c. Place one end of the tube extender into the drain body.

d. Slide the slipnut up the extender until it meets the drain body.

e. Thread the nut onto the drain body and tighten until snug.

Parts Included

• Push button pop-up with threaded body (1 pc.) • Nut • 1 Steel Washer • 2 Rubber Washers •

Parts Needed

▪1-1¼” x 1¼” slip nut ▪ 1-1¼” beveled washer ▪ 1-1¼” x 8” or 12” tube extender

Note: The above parts are not needed if using FV washbasin traps: Model# U242 or U242.01.

The necessary parts are included with the washbasin trap.

Umbrella

Drain

Tools Needed

• Adjustable Wrench • Pipe Putty or Teflon Pipe Tape •

Cat. No.

UD701

PAGE 1
Umbrella Drain Cat. No. UD701 INSTALLATION INSTRUCTIONS Parts Included • Push button pop-up with threaded body (1 pc.) • Nut • 1 Steel Washer • 2 Rubber Washers • Parts Needed ▪1-1¼” x 1¼” slip nut ▪ 1-1¼” beveled washer ▪ 1-1¼” x 8” or 12” tube extender Note: The above parts are not needed if using FV washbasin traps: Model# U242 or U242.01. The necessary parts are included with the washbasin trap. Tools Needed • Adjustable Wrench • Pipe Putty or Teflon Pipe Tape • Pop-up Instructions 1.