Installation & Assembly

ManualsBrandsBarclay ManualsFarmhouse/Apron Kitchen SinksChandra 30" L x 20" W Farmhouse Kitchen Sink

Farmer Sinks

INSTALLATION INSTRUCTIONS

P 847•244•1234 www.barclayproducts.com

2/19/13

Tools Needed

• Saber or Keyhole Saw • Ruler & Pencil • Sanding Block • Sealant (not included) •

• Sand Paper • Glasses • New Faucet (optional) •

TILE-IN INSTALLATION

1. This sink is designed for installation

flush with or slightly lower than the surrounding

tile.

2. Measure the sink apron and cabinet opening

to make sure sink apron will fit into cabinet

opening. If necessary, sand opening or add

wood filler strips.

3. Assemble faucet according to manufacturer’s

directions.

4. Place a thin layer of sealant at each corner of

the supporting frame where it will contact the

sink.

5. Gently position the sink within the frame,

placing the sink in the center of the cabinet.

UNDERCOUNTER INSTALLATION

1. The supporting frame should be positioned so that the top of the

sink rim (when placed inside the cabinet) is level and flush with

the top surface of the cabinet perimeter support or underlayment

at the cut out area.

2. Measure sink apron and cabinet opening to make sure sink

apron will fit into cabinet opening. If necessary, sand opening or

add wood filler strips.

3. Assemble faucet according to manufacturer’s directions.

4. Place a thin layer of sealant at each corner of the supporting

frame where it will contact the sink.

5. Gently position the sink within the frame, placing the sink in the

center of the cabinet.

6. Make sure the sink rim is level and flush with the cabinet

perimeter. Adjust or shim between the sink and the support if

needed to obtain proper fit. The top of the sink rim must be flush

with the top of the cabinet perimeter in order to obtain proper

contact with the underside of the counter top.

7. Assemble the strainer or garbage disposal to the sink according

to the manufacturers directions.

8. Using sealant between the sink and the cabinet is optional and

up to the buyers discretion.

Page 1 of 2

* The cabinet and supporting

framework should be reinforced to

hold up to 300 lbs securely once

the sink is installed. Typically this

involves a timber supporting frame

with 3/4” plywood deck or a brick

plynth.

Summary of content (2 pages)

PAGE 1
Farmer Sinks INSTALLATION INSTRUCTIONS Tools Needed • Saber or Keyhole Saw • Ruler & Pencil • Sanding Block • Sealant (not included) • • Sand Paper • Glasses • New Faucet (optional) • TILE-IN INSTALLATION UNDERCOUNTER INSTALLATION 1. This sink is designed for installation flush with or slightly lower than the surrounding tile. 1.
PAGE 2
Farmer Sinks SOLID SURFACE INSTALLATION 1. Follow steps 1-7 as outlined in the undercounter sink installation section. 2. Carefully measure the counter top to determine the exact location of the cut-out. 3. Measure the distance from finished wall to the center of the sinks faucet holes. This dimension will be used to locate the faucet hole centerline and back edge of the cut-out on the counter top.