Getting Started Guide

3/6
4/6
U-Spot DUO sensor activation
Once the sensor is physically installed, you can proceed with the
activation using the RFID Tool and the Activation Tool App.
1. Prepare the environment
❑ Make sure that the phone and RFID devices are fully charged.
❑ On the mobile phone, setup the correct date/hour and time zone.
❑ On the mobile phone, activate location and network services (GPS, WiFi or GSM).
❑ On the mobile phone, activate Bluetooth.
❑ On the mobile phone, disable the screen standby time.
U-Spot DUO activation
U-Spot DUO activation
2. Basic step-by-step flow
a) Login in the Activation Tool App
c) Set up the App
There are two ways of configuring the Activation app: one is manually (detailed steps
below), or by importing a specific config file provided by Urbiotica.
b) Connect with the RFID device
❑ Power ON the RFID device.
❑ From the mobile phone open the Activation
app, go to the sidebar menu from the left side, and
choose the option ‘Pair with RFID’ to connect the
RFID device, and check that the connection is
successful.
❑ RFID password: 1234
❑ Option 1: Manual configuration
On the ‘Current config file’ from the main menu
you can check and edit multiple options as the
LoRa region, the default node password and
node activation parameters.
Check that ‘Node is active’ is enabled.
NOTE: Nodes passwords are NOT stored by
Urbiotica. If changed, you are responsible for
managing this information on your own way.
❑ Radio settings
From the menu go to ‘Current config
file’ > ‘LoRa Region ‘, check that the
correct LoRa Region is set depending
of the radio frequency that is going
to be used.
NOTE: Keep in mind that the Network key must be obtained from the LoRaWAN
network provider.
➢ Radio Setting for LoRaWAN Europe and FCC (LoRaWAN network)
Select the LoRaWAN frequency type that is going to be used to communicate (for your
region) and write down the LoRaWAN network key in the “Lora Network Key” field.
➢ Radio Setting for LoRa Europe and FCC LoRa (U-Box LoRa gateways)
Select the LoRa frequency type that is going to be used to communicate (for your
region), and do NOT modified the network key in the “Lora Network Key” field.
To use LoRa frequencies a U-Box LoRa gateway must be installed.