User Guide

ADJUSTMENTS

Concealed Control

Dial

Knurled Dial Removal (See Figure-4 )

1. Remove the thermostat cover.

2. Secure the control dial with your hand so that the dial does not rotate.

3. Place needle nose pliers on the knurled ring of the control dial at the points where the

knurled ring is attached to the control dial.

4. Twist the pliers at each knurled ring attachment point until the entire knurled ring of the

control dial is removed.

Cover Insert

Installation

1. Select appropriate cover insert.

Note: If blank insert is used, the knurled ring must be removed from the setpoint dial. See

Knurled Dial Removal section. Also, remove dial window by sliding and/or pressing window

from front of cover.

2. Remove protective backing and protective skin on face of cover insert (see Figure-5 ).

3. Press insert uniformly on thermostat with logo in lower left-hand corner.

Limit Control Dial

Range

Dial Stop Pin Insertion (See Figure-6 )

1. Remove thermostat cover.

2. Secure the control dial with your hand so that the dial does not rotate.

3. Place a dial stop pin in the jaws of a needle nose pliers.

Control

Dial

Twist

Needle Nose

Pliers (above

connection post)

Knurled Ring

Connection

Post

Figure-4 Knurled Dial Removal.

Peel Off

Protective

Skin

Peel Off

Protective

Backing

Press Cover Insert

onto Thermostat Cover

Cover Insert (blank shown)

Figure-5 Cover Insert Installation.