User Guide

Figure-5 Dial Stop Pin Insertion.

COVER INSERT INSTALLATION (See

Figure 6)

1. Select appropriate cover insert.

Note:

If blank insert is used, the knurled ring must be

removed from the setpoint dial. See Knurled Dial Removal.

Also, remove dial window by sliding and/or pressing window

from front of cover.

2. Remove protective backing and protective skin on face of

cover insert.

3. Press insert uniformaly on thermostat with logo in lower

left-hand corner.

Figure-6 Cover Insert Installation.

MAINTENANCE

Regular maintenance of the total system is

recommended to assure sustained optimum

performance.

Open areas at bottom and around base of thermostat

should be kept clean and free from obstructions to allow

proper flow of air. If switch contacts need cleaning, this

may be done with TOOL-13 (burnishing tool).

Note:

Thermostat may require calibration after cleaning the

contacts.

REPAIR

These thermostats are not field repairable. Replace

entire device.

Figure-7 TC-110x-500 Typical of Parallel Heat Anticipation.