User Guide

2 © Copyright 2008 TAC All Rights Reserved. F-27169-6
Applicable Literature
SPECIFICATIONS
Actuator Inputs
Control Signal: See Table-1 for actuator models and control type.
Power Input: See Table-1. All 24 Vac circuits are Class 2. All circuits 30 VAC and above
are Class 1.
Connections: 3 ft (91 cm) appliance wire or plenum cables, enclosure accepts 1/2” (13
mm) conduit connectors. For M20 Metric connector, use AM-756 adaptor.
Actuator Outputs
Electrical:
Position Feedback Voltage (proportional or floating only),
For voltage ranges, the feedback signal is the same range as the input signal. The 4-
20 mAdc current range and floating actuators have a 2-10 Vdc position feedback
signal. The position feedback signal can supply up to 0.5 mAdc to operate up to four
additional slave actuators.
Mechanical:
Linear Stroke, 1/2” (13 mm) nominal.
Approx. Stroke Timing, See Table-1.
Manual Override, Allows positioning of valve and preload using manual crank.
Right/Left Jumper, Permits reverse acting/direct acting linear motion (MS51 only).
Environment:
Ambient Temperature Limits,
Shipping & Storage, -40 to 160 °F (-40 to 71 °C).
Operating, -22 to 140 °F (-30 to 60 °C).
Temperature Restrictions, For maximum ambient 140
°F (60 °C) the maximum
allowable fluid temperature should not exceed valve rating. See F-27252 Selection Guide
for specific ratings.
Humidity: 5 to 95% RH, non-condensing.
Location:
NEMA 1. NEMA 2 (enclosure is air plenum rated), UL Type 2 (IEC IP54) with customer
supplied water tight conduit connectors.
Agency Listings
UL 873: Underwriters Laboratories (File #E9429 Category Temperature-Indicating and
Regulating Equipment).
CUL: UL Listed for use in Canada by Underwriters Laboratories. Canadian Standards
C22.2 No. 24-93.
European Community: EMC Directive (89/336/EEC). Low Voltage Directive (72/23/EEC).
Australia: This product meets requirements to bear the C-Tick Mark according to the terms
specified by the Communications Authority under the Radio Communications Act 1992.
F-Number Description Audience Purpose
F-26080 EN-205 Water System Guidelines
– Application Engineers
–Installers
– Service Personnel
– Start-up Technicians
Describes TAC approved water treatment
practices.
F-27252
Vx-7xxx-8xx Series Vx-7xxx-59x Series Vx-9xxx-8xx
Series Vx-9xxx-59x Series Selection Guide
– Sales Personnel
– Application Engineers
–Installers
– Service Personnel
– Start-up Technicians
Provides Mxx1-720x and Mx51-710x
actuator, valve, and valve assembly
selection data including specifications,
close-off pressures, and dimensional
information.
F-26895
AM-703 Input Scaling Module, AM-704 Pulse Width
Modulation Interface, AM-705 Positioner, AM-706
Positioner, AM-708 Resistor
–Installers
– Service Personnel
– Start-up Technicians
Provides step-by-step mounting
instructions
F-27175
AM-756 Metric Conduit Adapter, AM-763 Hexcrank, AM-
770 Replacement Valve Linkage Parts Kit
Provides step-by-step mounting
instructions
F-27382 TAC Electric/Electronic Products Catalog
– Sales Personnel
– Application Engineers
Comprehensive catalog containing TAC’s
electric/electronic actuators, thermostats,
controllers, sensors, transmitters, and
accessories