User Guide

4 © Copyright 2008 TAC All Rights Reserved. F-26645-7
Table-1 Specifications.
ACCESSORIES
AM-671 Universal Mounting Bracket, AM-693 is required
AM-672 Universal Mounting Bracket, AM-693 is required
AM-673 Multiple Actuator Mounting Bracket (MA40-7153 series)
AM-674 Weather Shield
AM-675 Base Mounting Plate for AM-674
AM-676 Universal Shaft Extension, AM-710 required
AM-703 Input Rescaling Module, adjusts signals to 2-10 Vdc, zero and span adjustment
AM-704 Interface, pulse width modulation
AM-705 Positioner (NEMA 4 housing)
AM-706 Min and/or Manual Positioner for flush panel mount
AM-708 500Ω resistor for 0 to 20 mA control signal
AM-714 Weather Shield (polycarbonate)
AM-756 Metric Conduit Adapter M20 x 1.5 to 1/2” NPT
AM-761 7-inch replacement anti-rotation bracket
AM-762 9-inch replacement anti-rotation bracket
MS4X-7153-XXX and MS4X-7073-XXX
AM-686 Damper Position Indicator
AM-687 Universal Clamp for up to 1.05" (27 mm) diameter shafts
AM-688 Replacement Universal Clamp
AM-689 Rotation Limiter
AM-690 Crank Arm for round shafts up to 3/4" (19 mm)
AM-691 Crank Arm for jackshafts up to 1.05" (27 mm)
AM-692 V-bolt Kit for AM-690 and AM-691 Crank Arms
AM-693 Damper Linkage Kit
AM-758 Short “U” mounting bracket for replacing Honeywell Mod III type actuators and new
installations, AM-690 or AM-691 is required
AM-759 Tall “U” mounting bracket for replacing Honeywell Mod IV type actuators and new
installations, AM-690 or AM-691 is required
AM-760 Slotted “L” mounting bracket, AM-690 or AM-691 is required
AM-763 Crank for manual override
Part Number
Actuator Power Input
Approximate
Timing in
Seconds @ 70°F
(21°C)
a
a
Timing was measured with no load applied to the actuator.
Auxiliary
Switch
Output Torque
Rating
lb.-in. (N-m)
Auxiliary
Power
Supply
Input
Voltage
Running
Hold-
ing
Powered
Spring
Return50 Hz 60 Hz
DC
Amps
50/60
Hz
Min.
b
b
De-rating is required at low temperatures.
Max.
Stall
VA W VA W W
MS40-7043
24 Vac
± 20%
22-30
Vdc
5.6 4.2 5.6 4.2 0.15 2.4 <130 <25
No
35
(4)
150
(17)
None
2-10
c
Vdc or
4-20
d
mA w/
500 Ω
c
2-10 Vdc or 6-9 Vdc input impedance 80 k ohms.
d
4-20 mA with 500 ohm input impedance 500 ohms.
MS40-7043-
501
One
e
e
One adjustable from 0° to 95° rotation (0 to 1 scale).
MS4X-7073
5.8 4.6 5.8 4.6 0.17 2.3 <195 <30
No
60
(7)
250
(28)
MS4X-7073-
502
Two
f
f
One adjustable from 25° to 85° rotation and one set to operate @ 5° fixed.
MS4X-7153
9.8 7.4 9.7 7.4 0.28 2.9 <190 <30
No
133
(15)
350
(40)
MS4X-7153-
502
Two
f
MS40-7043-
MP
24 Vac
± 20%
22-30
Vdc
6.6 5.0 6.6 5.0 0.17 3.2 <130 <25
No
35
(4)
150
(17)
+20 Vdc
25 mA
Max.
6-9
c
Vdc
MS40-7043-
MP5
One