User Guide

18 © Copyright 2008 TAC All Rights Reserved. F-26645-7
E- Left E- Right
C
12
R
L Centerline
15
10
R
R
0°
14
5°
9
11
9. Loosen clamp nuts.
10. Check that the shaft is in full zero position.
For MS41-707X and MS41-715X only:
11. Tighten clamp nuts to 8 - 10 ft-lb (11 - 14 Nm).
This completes the installation for MA41-704X
and MA41-715X.
For MS40-707X and MS40-715X only:
12. Swing actuator
5° in the direction of travel. Do
not move shaft.
13. Tighten clamp nuts to 8 - 10 ft-lb (11 - 14 Nm).
14. Move bottom of actuator back into position.
15. Pivot bracket back into position.
12
R
C
L
Centerline
15
14
5°
L
0°
L
9
11
10
D - Left and Right
R
x 1
7
8
1/2
1/2
Center the
Universal Bracket in the Slot
5
6
x 2
5. Center bracket in slot.
6. Drill two holes.
7. Start one screw.
For MS41-707X and MS41-715X actuators, insert and tighten both screws.
8. Swing bracket down (MS40 actuator only).
#8 Sheet Metal
Screw
1
1
13
13