Product Overview

3. Make the required connections. Refer to Figure-1 or Figure-2 for a wiring diagram of your particular application.

4. Slip the conduit onto the base, over the ribs. Refer to Figure-7 and Figure-8.

5. Install the cover plate with two screws. The cover plate and two screws are supplied with the actuator.

6. If flexible conduit is to be installed on both sides of the actuator, repeat the preceding steps to install the second conduit.

Base

Knockout

Figure-6 Removal of Knockout on Actuator Base.

Ribs

Cover Plate

Base

Figure-7 Flexible Conduit Installation to Either Side of Actuator.

Transformer

(AM-610 shown)

4 x 4

Conduit

Box

Cover Plate

Leave Knockout in place

Line voltage motor leads when connected

to circuits other than Class 2.

Low voltage control leads may

be connected to a Class 2

circuit if routed separately

from line voltage circuit wiring.

Note: Class 2 circuit wiring must be routed

separately from wiring of other circuits. Do not

route Class 2 circuit wiring in the same conduit

box with the line voltage transformer.

Typical for 24 Vac

models (MP-54X3)

Figure-8 MP-5400 Series Wiring with Separation for Class 2 and Line Voltage Circuits.