Product Overview

Wiring Connections Wire Lead Connections (No Conduit)

Make connections as required. Refer to Figure-6.

Note:

Cover plate and screw supplied with actuator are not required with this method.

Installing 3/8" Flexible Conduit onto One or Both Sides of Actuator

Flexible conduit may be installed onto one or both sides of the actuator (refer to Figure-8 and

Figure-9). Install each conduit as follows:

1. Determine the side of the actuator to which the flexible conduit is to be attached.

2. Remove the knockout, using channel lock pliers, on the selected side of the actuator.

Refer to Figure-7.

3. Make the required connections. Refer to Figure-1, Figure-2, or Figure-3 for a wiring

diagram similar to your particular application.

4. Slip the conduit onto the base, over the ribs. Refer to Figure-8 and Figure-9.

Figure-6 Wire Leads Connection (No Conduit).

Base

Knockout

Figure-7 Removal of Knockout on Actuator Base.