Product Overview

REPLACEMENT PARTS

The installation of replacement actuators, in place of the obsolete series of MP-52xx

actuators, may require additional items. These replacement items are required for the

following reasons:

1. The AM-601 damper linkage is used to convert base actuators to damper actuators when

damper models are not available. Refer to Figure-20.

2. The AM-602 spacer is used when current actuators are installed on old linkages. Refer

to Figure-19.

3. The AE-249 transformer (208 Vac to 120 Vac) is used when replacing 208 Vac

actuators with 120 Vac actuators.

4. Resistors are required when an obsolete TP-5xxx or CP-51xx controller is used to

control a current actuator. Detailed resistor and wiring information is provided in section

C1.1 of

Engineering Bulletin EN-111 (TAC System 8000 Electronic Control), F-15264

1-5/8"

(41mm approx.)

1-5/8"

(41mm approx.)

Obsolete Linkages

Current Linkage

2-3/16"

(56mm approx.)

Spacer

AM-602

Figure-19 Current or Obsolete Valve Linkage.

Current AM-601-0-0-2

No Strap

Figure-20 Current or Obsolete Damper Linkage.

Strap

Obsolete AM-601