User Guide

Installing Conduit Box Onto Actuator

Installation of a conduit box allows for the attachment of one or more thin wall conduits to

the actuator. This procedure also serves as an optional method for connecting flexible

conduit to the actuator.

1. Remove the knockout from the cover plate supplied with the actuator. Refer to Figure-10.

2. Slip the actuator’s leads through a standard 1/2” conduit bushing (Figure-11, not

supplied) and the knockout hole in the cover plate. Refer to Figure-12.

3. Seat the conduit bushing in the base.

4. Install the cover plate, using the two screws provided.

5. Loosely install the conduit box and the locknut onto the conduit bushing. Refer to

Figure-13.

Cover Plate

Knockout

Figure-10 Cover Plate Knockout Removal.

1/8" (3 mm) maximum

Use TAC 11-1612,

Bridgeport 1102-DC,

or equivalent

Figure-11 1/2" Conduit Bushing.

1/2" Conduit Bushing

(not supplied)

Base

Cover Plate

Figure-12 Conduit Bushing and Cover Plate Installation.