User Guide

22 © Copyright 2007 TAC All Rights Reserved. F-15479-8
Typical Actuators which require CP-8391-913 purchased separately: MP-361,
MP-371, MP-381, MP-382, MP-2113-500.
Figure-19 External Wiring for CP-8391-913, 4 to 20 mAdc Interface with 24 Vac Actuators.
Typical Actuators which require CP-8391-910 purchased separately: MP-421,
MP-422, MP-424, MP-451, MP-452, MP-453, MP-454.
Figure-20 External Wiring for CP-8391-910, 4 to 20 mAdc Interface with Line Voltage Actuators without Internal Transformer.
4
5
6 7
3
8
2
H
1
G
X
Green Wires
Case
Ground Screw
Blue (-)
4 to 20 mAdc
Controller Input
Yellow / Black
Blue / Black
Red / Black
Brown
Brown / White
Brown / Black
CP-8391-913
Solid State
Actuator Drive
(4 to 20 mAdc
Nonadjustable
Range)
Black
To 24 Vac
Power Supply
Orange (+)
Black / Blue
1
1 The Blue wire on the CP-8391-913 is grounded. To unground the Blue wire, remove the Green
jumper wire between terminal x and case ground screw.
2 The actuator rotates clockwise on an increasing mAdc input signal between Blue (-) and
Orange (+). To rotate the actuator counterclockwise on an increase in input signal, reverse
Blue/Black and Red/Black leads and reverse Brown/Black and Brown/White leads.
2
1
4
5
6 7
3
8
2
L1
1
L2
X
Green Wire
Case
Ground Screw
Blue (-)
4 to 20 mAdc
Controller Input
Yellow / Black
Blue / Black
Red / Black
Brown
Brown / White
Brown / Black
CP-8391-910
Solid State
Actuator Drive
(4 to 20 mAdc
Nonadjustable
Range)
Black
To 120 Vac
Power Supply
Orange (+)
White
1
2
1
1 The Blue wire on the CP-8391-910 is grounded. To unground the Blue wire, remove the Green
jumper wire between terminal x and case ground screw.
2 The actuator rotates clockwise on an increasing mAdc input signal between Blue (-) and
Orange (+). To rotate the actuator counterclockwise on an increase in input signal, reverse
Blue/Black and Red/Black leads and reverse Brown/Black and Brown/White leads.