Product Overview

3. Seat the conduit bushing in the base.

4. Install the cover plate, using the two screws provided.

5. Loosely install the conduit box and the locknut onto the conduit bushing. Refer to

Figure-11.

6. Tighten the locknut as follows:

a. Tilt the conduit box approximately 30 degrees counterclockwise, relative to the

actuator.

b. Finger-tighten the locknut against the conduit box.

c. Rotate the conduit box clockwise until it is aligned with the actuator. This will tighten

the locknut.

7. Make the required wiring connections. Refer to Figure-1 for a wiring diagram of a typical

application.

8. Install the conduit to the conduit box as required.

Note:

As shown in Figure-10, the hole in the cover plate of the actuator conduit housing is

sized to accept both British standard M20 (20 mm) conduit connectors and 20 mm-to-PG16

adaptors for use with DIN PG16 connectors. (Follow the steps for installing the conduit box

to the actuator.)

Figure-10 Conduit Bushing and Cover Plate Installation.

1/2" Conduit Bushing

(not supplied)

Base

Cover Plate

Figure-11 Attachment of Conduit Box to Conduit Bushing.