User Guide

8 Copyright 2008 TAC All Rights Reserved. F-26563-2
Blue
1 Caution: Before installing the CP-9301 or CP-9302 onto
actuators equipped with an
internal transformer , disconnect the
red and blue leads from actuator terminals 7 and 8, and tape
off.
Failure to do so will result in damage to the actuator drive.
2 The L1 and L2 terminals are marked H and G on 24Vac
actuators.
3 Purge override (input signal override) is available on CP-9302
only. A dry contact closure from the purge (override) input lead
(violet/white) to the blue lead of the actuator drive forces the
actuator to drive to the end of travel, independent of the input
signal conditions. Connecting the violet/white and violet leads
together forces the actuator to drive to the opposite (high input
signal) end of travel, independent of input signal conditions. If
the purge override (input signal override) function is not used,
be sure to tape off the violet/white and violet leads.
4 MP-XXXX-XXX-X-2 models are equipped with an external
green jumper from terminal X to the terminal block mounting
screw (ground). If the application requires it, this jumper may
be removed for isolation purposes.
5 24 Vac models are equipped with a jumper from terminal G to
the case ground screw.
6 As diagrammed, increasing input causes CW actuator rotation.
For CCW rotation with an increasing input signal, reverse
blue/black and red/black leads, and reverse brown/black and
brown/white leads. All references to the direction of rotation are
determined by facing the actuator output shaft.
7 Ground the shield wire and the drive's green/yellow ground wire
at the actuator's terminal block mounting screw.
Drive Input (+)
Common (-)
3
4 to 20 mAdc
Controller Input
Purge Override
(Input Signal
Override)
Yellow / Black
Blue / Black
Red / Black
Brown
Brown / White
Brown / Black
Yellow
2
4
6
7
5
6
Violet/White
Purge Input (Override Input)
Violet
Purge + (Override +)
1
Terminal Block
Mounting Screw
(Ground)
Case Ground Screw
Green/Yellow
Shield Wire
Actuator
AC Supply
X
5 6
7
3
2
1
8
L1
L2
4
CP-9301
or
CP-9302
Drive
Figure-8 Installation Wiring Diagram for Current Inputs.