User Guide

4 Copyright 2008 TAC All Rights Reserved. F-26563-2
Voltage Input
from Controller
Yellow (OP1)
Blue (COM)
Yellow (OP1)
Blue (COM)
Yellow (OP1)
Blue (COM)
1
1
1
2
1 Actuator drives configured for voltage input.
2 The maximum number of actuators that may be
connected to one controller is limited by the
amount of current the controller can supply.
To Additional
Actuators
+
_
Figure-2 Typical Control Wiring for Multiple Actuators with Drives Configured for Voltage Input.
Yellow (+)
Blue (-)
Blue (-)
3
3
1 2
2
1 Actuator drives configured for
current input.
2 This diagram shows a typical
installation consisting of two
actuators connected in series.
When configured for current
input, the maximum number of
actuators that may be
connected to one controller is
limited by the amount of voltage
the controller can supply.
3 CP-9302 actuator drives are
available with a purge override
(input override) feature. Use of
this override feature is optional.
Purge Override
(Input Signal Override)
Purge Input (Override Input)
Purge + (Override +)
Current Input
from Controller
Yellow (+)
Blue (-)
+
_
1
CP-9301
CP-9302
Figure-3 Typical Control Wiring for Two Actuators with Drives Configured for Current Input.