User Guide

Wiring Connections

CP-8391-456

1. Wire the appropriate eyelet pigtail leads, from the group of eight from one side of the drive,

to the screw terminals on the actuator.

2. Wire the appropriate eyelet pigtail leads, from the group of three from the drive, to the

screw terminals on the actuator. Note: One of the leads will be taped-off; see Power

Lead section.

3. Wire the Red (+) and Black (–) pigtail leads to the Vdc controller.

4. Replace the actuator cover.

Figure-8 CP-8391-456 Wiring and Mechanical Arrangement

(shown for MP-400, MP-2100 series and MP-9750 actuators).

CP-8191-456

1. Pull all wires to the drive.

2. Wire to the appropriate screw terminals on the drive. See Figure-7 for locations.