User Guide

F-24190-3 © Copyright 2008 TAC All Rights Reserved. 5
INSTALLATION
Inspection
Inspect the carton for damage. If damaged, notify the appropriate carrier immediately.
Inspect the device for obvious damage. Return damaged products.
Requirements
• Job wiring diagrams
• Tools (not provided):
Common, single slotted screwdriver
CP-8191-456, appropriate drill and bits
CP-8391-456, wire cutters, ballpeen hammer, electrical tape
• Training: Installer must be a qualified, experienced technician
W
C A U T I O N
• Disconnect the power supply (line power) before installation to prevent equipment
damage.
• Make all connections in accordance with the wiring diagram and in accordance with
national and local electrical codes.
Use copper conductors only.
• Do not exceed ratings of the device(s).
• Avoid locations where excessive moisture, corrosive fumes, or vibration is present.
Controller
Red
+
Black
–
Red
+
Black
–
Red
+
Black
–
+–
CP-8191-456
or
CP-8391-456
CP-8191-456
or
CP-8391-456
CP-8191-456
or
CP-8391-456
Figure-5 Wiring for Parallel Application.