User Guide

F-24190-3 © Copyright 2008 TAC All Rights Reserved. 3
TYPICAL APPLICATIONS (wiring diagrams)
Figure-1 Typical Wiring Diagram, CP-8X91-456 to MP-4XX & MP-21XX Series and MP-9750 Actuators,
Increasing Input Signal, CCW Actuator Rotation.
Figure-2 Installation Wiring Diagram, CP-8X91-456 to MP-4XX & MP-21XX Series and MP-9750 Actuators,
Increasing Input Signal, CW Actuator Rotation.
4
5
6
7
8
L1
L2
3
2
1
X
Actuator
Red/Yellow (x)
Black/Blue (2)
White/Blue (3)
Brown (4)
Red (+)
Black (-)
To Volts DC
Controller
CP-8191-456
or
CP-8391-456
Actuator
Drive
Yellow (7)
Orange (8)
Blue (120 Vac*)
Violet (COM*)
Black/White (240 Vac*)
(Wire to L1 on 240 Vac
actuators and tape
Blue lead.)
(COM)
AC Supply
CAUTION: Actuator must not
have built-in transformer; or if a
built-in transformer is present,
remove red and blue leads
from the transformer to termi-
nals 7 and 8 and tape off.
Note: All references to direc-
tion of actuator shaft rotation
are determined by looking at
the face of the actuator with
the output shaft.
* CP-8191-456 power can be
supplied by source other
than actuator.
CP-8391-456 Wire Color
CP-8191-456 Terminal Identification shown in ( )
4
5
6
7
8
L1
L2
3
2
1
X
Actuator
Red/Yellow (x)
Black/Blue (2)
White/Blue (3)
Brown (4)
Red (+)
Black (-)
Input Signal
from Controller
(Volts DC)
CP-8191-456
or
CP-8391-456
Actuator
Drive
Yellow (7)
Orange (8)
Blue (120 Vac*)
Violet (COM*)
Black/White(240 Vac*)
(Wire to L1 on 240 Vac
actuators and tape
Blue lead.)
(COM)
AC Supply
CAUTION: Actuator must not
have built-in transformer; or if a
built-in transformer is present,
remove red and blue leads
from the transformer to termi-
nals 7 and 8 and tape off.
Note: All references to direc-
tion of actuator shaft rotation
are determined by looking at
the face of the actuator with
the output shaft.
* CP-8191-456 power can be
supplied by source other
than actuator.
CP-8391-456 Wire Color
CP-8191-456 Terminal Identification shown in ( )