User Guide

10 © Copyright 2008 TAC All Rights Reserved. F-24190-3
CHECKOUT
After the entire system has been installed and powered, apply minimum and maximum input
signals to CP-8X91-456 and check for correct operation of the actuator.
MAINTENANCE
Regular maintenance of the total system is recommended to assure sustained optimum
performance.
SERVICE
See Figure-10 and Figure-11 for wiring diagrams if additional wiring information is required
on actuator/electronic drive combinations.
W
C A U T I O N
Actuator must not have built-in transformer; or if a built-in transformer is present, remove red
and blue leads from the transformer to terminals 7 and 8 and tape off.
FIELD REPAIR
No field repair is possible.